Description
Part Number: 2361
Jumbo-S LED stop, rear position lamp with in built 23cm² red retro reflector, featuring Enhanced Definition Technology (EDT) for the stop signal function. New low profile design allows surface mounting with gasket accessory (P/N 9.2361.08).
Other Details:
| 2361 | 2TA 980 760-011 |
|---|
| 2361BL | 2TA 980 760-012 BLISTER PACK |
| Mounting | Retrofit to update existing Jumbo or Designline lamps.
Suitable for horizontal or vertical mounting. |
| Voltage | Multivolt for optimum brightness in 12 and 24 volt systems. |
| Power Consumption | Stop: 5W
Rear position: 1W
|
| Protection | Reverse polarity and 5000 watt Transient Voltage Suppressor (TVS)
IP 6K7 (Protection against dust and temporary water immersion)
IP 6K9K (Protection against dust and high-pressure/steam jet cleaning) |
| Cable Length | Pre-wired with 200mm of cable.
|
| Compliance | ADR 47/00 ADR 49/00 RCM Compliant |
Shipping
After ordering online, you will receive an email confirmation containing your order details from [email protected]. Your order will be confirmed within a few minutes of placing your order.
It is our policy to ensure we deliver to our customers in a timely manner. In order to achieve this we use a range of freight companies depending on the size and weight of your order. In some instances we may use a number of carriers to get your products to you. For example chain may come by road, some electronic equipment by air.
All orders delivered to Australian Post Codes attract a flat rate $18.00 shipping charge.
International orders will be charged at $0.00 initially and our staff will be in contact with a shipping quote. If the quote is not accepted the customer reserves the right to cancel their order and be refunded in full.
Should you have any queries or concerns about shipping, please contact us and we will have somoene get back to you.
